OD=NORMAL, MODE=INACTIVE, SLEW=STANDARD_MODE, FILTEROFF=FILTER_ENABLED, DIGIMODE=ANALOG_MODE, INVERT=DISABLED
Digital I/O control for port 0 pins PIO0_0 to PIO0_15.
| FUNC | Selects pin function. |
| MODE | Selects function mode (on-chip pull-up/pull-down resistor control). 0 (INACTIVE): Inactive. Inactive (no pull-down/pull-up resistor enabled). 1 (PULL_DOWN): Pull-down. Pull-down resistor enabled. 2 (PULL_UP): Pull-up. Pull-up resistor enabled. 3 (REPEATER): Repeater. Repeater mode. |
| RESERVED | Reserved. Read value is undefined, only zero should be written. |
| INVERT | Input polarity. 0 (DISABLED): Disabled. Input function is not inverted. 1 (ENABLED): Enabled. Input is function inverted. |
| DIGIMODE | Select Analog/Digital mode. 0 (ANALOG_MODE): Analog mode. 1 (DIGITAL_MODE): Digital mode. |
| FILTEROFF | Controls input glitch filter. 0 (FILTER_ENABLED): Filter enabled. Noise pulses below approximately 10 ns are filtered out 1 (FILTER_DISABLED): Filter disabled. No input filtering is done |
| SLEW | Driver slew rate. 0 (STANDARD_MODE): Standard mode, output slew rate control is enabled. More outputs can be switched simultaneously. 1 (FAST_MODE): Fast mode, slew rate control is disabled. Refer to the appropriate specific device data sheet for details. |
| OD | Controls open-drain mode. 0 (NORMAL): Normal. Normal push-pull output 1 (OPEN_DRAIN): Open-drain. Simulated open-drain output (high drive disabled) |
| RESERVED | Reserved. Read value is undefined, only zero should be written. |